
MLCS Heavy Duty Router Speed Control 20 amp
Need Product Support?
1.800.533.9298
MLCS Heavy Duty Router Speed Control 20 amp allows a woodworker to reduce the speed of a router without reducing torque. Electronic feedback maintains speed by increasing voltage to motor as load increases. Work at the best speed for the bit and the wood. Recommended for industrial and commercial use. Simply plug in speed control then plug your router into the speed control. Adjust speed from 0 RPM to full speed.
Features
Less tear out • Stops burning • Feed at comfortable rate
Better, safer results with large diameter panel raising bits
Less wear on bits • Less noise • Softer starts at lower speeds
Adjustable speed from 0 RPM to full speed
3 position rocker switch- Variable / Off / Full Speed
Full power and torque at all speeds
Go back and forth from any preset speed to full speed at the flip of a switch
Works with most routers 3-1/4 HP or less • 120V
Give your router a feature only available on expensive routers
Easy to use- Simply plug in speed control and plug your router into the speed control- turn dial slowly for best results. (Speed control has a clip that can be worn on your belt, hung on wall, or left loose).
Dust Cover Included (not shown in photo)
WARNING
Will not work with soft start or variable speed routers.
Will not work with "AC capacitor start induction" type motors.
NOTICE
LOADS OVER 15 AMPS ONLY
Variable Speed Controllers are calibrated to the amperage load of the tool connected to it. The 20 AMP Variable Speed Controller is factory calibrated for amperage loads OVER 15 AMPS. If your tool does not have a load OVER 15 AMPS, your tool will not work properly with this Variable Speed Controller.
For tools up to 15 AMPS, use the 15 AMP Variable Speed Controller # 9400.
You May Also Like