Lock Miter, Drawer Lock, Glue Joint Router Bits Set 1/2" shank | MLCS PREMIUM
Need Product Support?
1.800.533.9298
MLCS Premium Lock Miter, Drawer Lock, Glue Joint Router Bits Set has the router bits to make lock miter joints, drawer lock joints and glue joints all in one set.
Glue Joint Bit #18846:
Makes a reversible glue joint that has a 50% greater glue surface than a butt joint.
These bits are designed to cut a profile on the edges of the wood that allows them to fit together perfectly, creating a tight bond when glued.
They produce a strong glue edge joint for door panels, table tops, and cabinets.
Center the cutter on the stock and cut both tongue and groove in one pass. Flip wood, cut matching side, then assemble.
All bits two flute, carbide tipped.
Use with stock up to 1-1/4" thick.
Large Diameter: 1-1/2".
Cut Height: 1-1/4".
Shank: 1/2".
Drawer Lock Bit #18850:
Attaches sides to front of drawer with strong, perfectly mating glue joints.
Minimum stock thickness is 3/8" for drawer sides and 1/2" for drawer front.
Maximum stock 3/4".
All bits two flute, carbide tipped.
Large Diameter: 2".
Cut Height: 1/2".
Shank: 1/2".
Lock Miter Bit #17850:
Cuts a perfect matching tongue and groove glue joint to join materials at 90° by cutting a 45° miter.
This extremely strong joint not only increases mechanical strength, but also increases glue surface area and automatically aligns parts.
Make frames, boxes, right angle and parallel angle joints.
Two flute, carbide tipped.
Large Diameter: 2-3/4".
Cut Height: 1-3/16".
Stock Thickness: 5/8" - 1-1/16".
Shank: 1/2".
The MLCS Premium Difference.
Lifetime Guarantee: Against Defects in workmanship and materials.
Micro-grain carbide: Premium fine grain carbide yields a longer cutting life, and allows multiple resharpenings.
High Hook & Shear angles: Allows cutter to slice smoothly into stock, producing the cleanest, splinter free cuts.
Anti-kickback design: Round shoulder between cutters drastically reduces the chance of kickback.
Non-stick coating: Baked on heat resistant coating prevents sawdust, resin and pitch build-up.
Safety Gauge Shank: Lines etched on the shank help you seat the bit in the router collet.
Setup Blocks
| Glue Joint Bit #18846 | Setup Block #9781 |
| Drawer Lock Bit #18850 | Setup Block #9784 |
| Lock Miter Bit #17850 | Setup Block #9754 |
Watch How to Make a Glue Joint !!!
Watch How to Make a Drawer Lock Joint !!!
Watch How to Make a Lock Miter Joint !!!
You May Also Like
